SUPPORT - MANUALS & DOWNLOADS
Other Tools

Dot Inspector

Use one plate only – perform 4 plate-setter tests at once!

Simple Pre-Qualifier for plate setters.
 

This test form enables plate qualifying:

  1. Process control (checker test)


  2. Tone Reproduction Curve measurement for plate linearisation purpose





    values on bottom represent real readings for 8 -bit data

  3. Uniformity 

  4. Registration / repeatability accuracy



 Additional tools required:

  • Dot Meter
  • Microscope or magnifying glass 
  • Ruler

 


Procedure

Check if it is possible to expose a plate on CtP without processing it.   I f you can turn punching option off.

Next do as follows:

  1. Select proper Dot Inspector (positive/negative and resolution related to plate setter's used in production)
  2. In CtP RIP utility define minimal page size, enlarging area with no TVI compensation. Use this space to place ChromaChecker Dot Inspector test form. Ideally make an array e.g. 3x4  to control different areas of the plate: left/center/right  and top/ center/bottom.



  3. Use only one plate and expose it four times (CMYK) -  but do not process it
  4. Finally, process it
  5. Check if checker test pass -if not fix processor 
  6. Check plate uniformity - measure and compare 50% C in for location on the plate. If all measurement are on tolerance  (+/- 1%) go to next step
  7. Measure TRC in at least 3 different location - if no uniformity issue – average result for the plate  linearization
  8. Use a magnifying glass or a digital microscope (recommended) to the visual judgment of repeatability / registration. If gaps appears inside crosses measure them for all location

  


How to measure displacement with a ruler?



Close-up of displacement test exposed on plate (picture taken with digital microscope) 


 

  With common ruler measure the gap i both horizontal and vertical directions

   next calculate displacement 1 mm = 25μ

     gap 2mm = 50 μ     

 

   gap 4mm = 100μ      

 

  gap 6mm = 150 μ      

 

  gap 8mm = 200μ       

 

 gap 10mm = 250μ      

 

 

 Dot Inspector P 2400 dpi (positive)
Dot Inspector P 2540 dpi (positive) 

 


Production test form: Dot Inspector M 

This simple form is dedicated for TCR checking and process control only.




 ChromaChecker™ Dot Inspector M test form in regular production QC

 

 Dot Inspector M 2400 dpi (positive)
 Dot Inspector M 2540 dpi (positive)