This project is based on the Idealliance ISO 12647-7 Control Wedge 2013 and is designed to demonstrate how users can verify a hard proof and the print certification label. A variety of label sizes is predefined.

You can upload existing measurement data to the project. Alternatively, other control strips, such as the Ugra/Fogra Media Wedge, are also supported for upload.

Check your instrument by measuring it with Instrument Inspector. This test form can be used as a short-term target.

Steps to test Instrument Inspector:

Create a baseline in scan mode with Instrument A.
Create another baseline in spot mode with Instrument A.
Repeat the same steps with instruments B, C, etc.
Compare baselines of different modes and instruments.
Remeasure the same target to verify if the instrument is consistent over time.