Lenovo ThinkPad Windows 10 Tablet with 4GB ram connected with Xrite eXact using BT connection.

The connection uses an auto-connect feature and the Operator is a member of the team that has Scratchpad as a startup Inspector for CC Capture.

The video presents how to work with Projects. The steps are as follows:

1. Launch  CC Capture application
   
   
2. Enter the operator's credential 
   
   
3. Set Job ID - save it!
   The job ID is mandatory only if the user needs to save measurements - for checking only it is not. 
4. Measure Substrate 
   This step is not mandatory, however, the substrate can be defined as a component of the Project and in this way can be tracked. Also, some additional predictions require the substrate to be measured in advance.  Density calculation uses substrate for a relative mode (minus paper). The user during the session doesn't need to measure substrate until it is the same. Any time Substrate measurement can be updated.  
5. Measure the first color sample
   In This step, the measurement is taken and can be exported to the Assets ( Color Library or Color Palette)
   
   
6. Set source of the Reference: Project
   There are a lot of possibilities to select from - Project is one of them. In this case, a list of color standards is reduced to being active in a given Project. That makes autorecognition effective and keeps references  
   
   
7. Select a Project from the list
   The on-screen report is displayed at the bottom of the page. Measurement can be saved manually or using auto-save but in most cases first, a few measurements are made for make-ready purpose
8. Measure the second sample
   Thanks to autorecognition reference can be selected without the operator's intervention

In the next step (when makeready is complete) selecting the auto-save option will automatically send all data to the CC account ( Tracking in Color Inspector).